Today we’re going to install the Polaris 360; much like the other Polaris cleaners, we can have the 360 up and running in a few steps. In our pool we have a dedicated return line with a 1-1/2” female fitting. If you don’t have a dedicated return line please refer to your manual page 5.

The first flush out the return line by turning the pump on for a minute and then turn it off. Next, install the universal wall fitting (UWF) by disconnecting it from the quick connect and screw it on to the fitting. Now re attach the quick disconnect by inserting it into UWF, turn clockwise and pull.

Note: At this point If you have multiple return lines, eyeball regulators need to be installed in the lines to ensure adequate line pressure. Please refer to your manual for help with this...

Now we are going to install the highly regarded Polaris 3900 Sport. The pool for our example has a dedicated return line with a 1-1/2” female fitting.

Make sure to flush out the return line by turning the pump on for a minute and then turn it off before we start. Next, install the universal wall fitting (UWF) by disconnecting the UWF from the quick connect and screw it on to the fitting with the blue restrictor plate in between the UWF and the return line. Now re attach the quick disconnect by inserting it into UWF, turn clockwise and pull...

For our Pentair Legend installation, our booster pump has 1-1/2” female line from our booster pump. This is what the Legend comes equipped to connect to. If you have to install your booster pump, refer to your manual or view our install guide here. So let’s get started…

As with most pool cleaners we’re going to install the twist lock pressure relief valve (wall fitting) first, be sure to disconnect your current cleaner, and run your pump for a minute or so to clear out the line. Now remove your current wall adapter from...…

For today’s project, were going to install the Pentair legend II, this specific unit does not require a booster pump so we will install it to our existing return line. So let’s get started…

First if you have an existing cleaner or wall fitting, take it out then turn on the filter pump to flush out the line for a minute and turn off the pump. Now remove the wall adapter from the wall fitting, next screw the adapter by hand to your dedicated return line. You should now be able...