How to Start Your Spa With Nature2

If you purchased a Nature2 spa stick and are having trouble trying to figure out how to install it in your spa, we are here to help. The good news is your one step closer to using fewer chemicals in your spa and installing is relatively easy. Nature2 is made to work with most portable spas (no built in spas), and as always you would refer to the manual if you have any questions.

The first thing you need to do before installing your Nature2 is to drain your spa water and then refill it and balance the water. This is important because for your Nature2 to work efficiently, it needs to be used in properly balanced water.

Once the water is balanced you can put together the Nature2 stick by connecting the support stems and press them onto the main body to create the unit. Here is a diagram of the included pieces:

Now you can place the Nature2 in the core of your existing spa filter cartridge, when installed the Nature2 must me at least 1” above the bottom of the filter to prevent water blockage. Here is a few examples of how to install in different filter setups:

Once you have your Nature2 stick installed in your filter, you need to super oxidize the spa water with Dichlor (Sodium dichloroisocyanurate dehydrate) to burn off contaminants and activate the cartridge. To do this we recommend using an EPA registered source of chlorine according to your spa manufactures instructions. After the water has a residual chlorine level of over 5 ppm you can re enter the spa and run it according to manufactures recommendations.

You now have installed your Nature2 and can enjoy, we do recommend reading the manual for operation and maintenance for a low chlorine recipe spa.

Check out our entire selection of Nature2 products…