Raypak Digital ASME Commercial Copper Pool Heater with Copper Heat Exchanger, Electronic Ignition, Digital Thermostat
Digital LCD for temperature control and heater settings
2" glass-lined Cast Iron headers
Microprocessor controls diagnostic readout and continuously monitors operational status
Unitherm governor eliminates condensation
125# pressure relief valve
ANSI Z21.56 design certified
Altitudes from Sea Level to 9,000 ft.
ASME rated heaters are intended for use when local codes mandate the use of ASME-certified equipment in commercial installations, such as apartment, condominium and public pools and spas. The Raypak commercial digital heater is factory equipped with ASME waterways for commercial use and comes with a microprocessor based thermostat control. This allows the user to set the pool or spa temperature at a precise temperature using the up or down button. The digital display provides a constant reading of the pool's water temperature.
Pool Heater Highlights:
The Raypak Digital gas heater comes with a microprocessor based thermostat control. This control allows you to set your swimming pool or spa temperature precisely at your favorite setting just by pressing an up or down temperature control button. The digital display gives you a constant read out of your swimming pool water temperature.
Troubleshooting a gas heater has never been easier. The Raypak Digital has on-board diagnostic controls that let the user and the service professional know what is going on with the heater at all times. In the event that you would ever have a problem with the heater, the digital display will show where the problem is in the control circuit.
The Raypak Digital is compatible with most major swimming pool control and remote systems on the market today. Any two-wire or three-wire remote can connect to the Raypak Digital and be integrated into the pool control system of your choice.
Copper Heat Exchanger
All Raypak ASME gas heaters come standard with .065" wall integral copper finned tubes. This tubing is over 50% thicker in wall thickness than standard tubing. Since the fins are integral to the tube, maximum heat transfer is attained. The fin tubing is made from one piece of extruded copper tube, not from separate fins attached to the copper tubes. Every Raypak ASME has the same robust design tube bundle that is used in Raypak's large gas commercial boilers.
Raypak ASME Digital Specifications:
0 - 2,000 ft
2,000 - 3,000 ft
2,000 - 6,000 ft
3,000 - 5,000 ft
5,000 - 7,000 ft
6,000 - 9,000 ft