Water Leveler Features:

• The Pool water level is controlled automatically with +/ - 1/8" (12mm) of normal water level. The High Level is monitored 3" lower to within +/ - 1/8".
• Water level control system includes a fill sensor and a Low Water level sensor with wire attached, a control panel, and a solenoid valve.
• Sensor Static pipe should be installed according to the drawings, with 2" PVC with no reductions.
• Fill sensor should be mounted at water level, inside the static pipe located according to the drawings.
• Units with floats or moving parts will not be considered as equal and shall be rejected.
• Sensor should be connected to the control panel with a maximum of 200' of wire provided as part of the system. Sensor wire comes in 50 ft increments with a maximum of 200'.
• Control panel displays indicating Power, Sensor active, Filling active Low Water Sensor active and Low Water Cut-Off.
• System has adjustable feed alarm suitable for the application as determined by the drawings.
• System has a time delay between sensing and filling before initializing the Solenoid Valve.
• System is shipped with 220VAC 50/60Hz, field adjusted for 110VAC and is hard wired into a panel for permanent installation.
• Solenoid valve offered in brass or fiberglass and sized according to the drawings and normally closed, 24VAC and 0.6amps at a peak, as supplied with the level control system.
• The Relay supplied by the Electrical Contractor must be normally open and have a contact rating suitable for operating the pump in the “System" and should be 24VDC for coil operation with 0.6amps at peak.

Resources:

	Levolor Data Sheet
	K-2100 Operational Manual