Water Leveler Features:

• The pool water level is controlled automatically with +/ - 1/8" (12 mm) of normal water level.
• Water level control system can include a sensor with wire attached, a control panel, a solenoid valve in-line with make-up water, and a 24VCD relay supplied by the electrical contractor with suitable rating to operate the pump.
• Sensor Static pipe should be installed according to the drawings, with 2" PVC with no reductions.
• Sensor should be mounted at water level, in a safe and convenient location according to the drawings.
• Units with floats or moving parts will not be considered as equal and shall be rejected.
• Sensor should be connected to the control panel with a maximum of 200' or wire provided as part of the system. Sensor wire comes in 50' increments with a maximum of 200 ft.
• Control panel displays indicating Power, Sensor active, Filling active, High Water Sensor active and High Water pump active.
• System has adjustable High Water alarm suitable for the application as determined by the drawings.
• System has a time delay between sensing and filling before initializing the Solenoid Valve.
• System is shipped with 220VAC 50/60Hz, field adjusted for 110VAC and is hard wired into a panel for permanent installation.
• Solenoid valve offered in brass or fiberglass and sized according to the drawings and normally closed, 24VAC and 0.6mps at a peak, as supplied with the level control system.
• The Relay supplied by the Electrical Contractor must be normally open and have a contact rating suitable for operating the pump in the

Resources:

	Levolor Data Sheet
	K-2000 Operational Manual