Water Leveler Features:

• Enclosure: 10" x 5" x 4.5" with mounting screws
• Sensor: Two Probes (Skimmer Sensor and Static Pipe Sensor) – Wire 50ft-200ft in 50ft Increments
• Valve: 1" 24VAC Solenoid
• Sensor Housing: 5.5" in diameter
• The Pool water level is controlled automatically with +/ - 1/8" (12mm) of normal water level.
• Water level control system includes a sensor with wire attached, which installs at the nominal water I control panel, mounted in the equipment area and a solenoid valve in-line with make-up water.
• Sensor Static pipe should be installed according to the drawings, with 2" PVC with no reductions.
• Units with floats or moving parts will not be considered as equal and shall be rejected.
• Sensor should be connected to the control panel with a maximum of 200 ft of wire provided as part system. Sensor wire comes in 50 ft increments with a maximum of 200 ft.
• Control panel displays indicating Power, Sensor active & Filling active.
• System has adjustable feed alarm suitable for the application as determined by the drawings.
• System has a time delay between sensing and filling before initializing the Solenoid Valve.
• System is shipped with 220VAC 50/60Hz, field adjusted for 110VAC and is hard wired into a panel for permanent installation.
• Solenoid valve offered in brass or fiberglass and sized according to the drawings and normally closed 24VAC and 0.6amps at a peak, as supplied with the level control system.

Resources:

	Levolor Data Sheet
	Jandy Levolor Owners Manual